
16.1 About This Command
You can use the RECEIVE DIAGNOSTIC RESULTS command for any
of the following purposes:
Obtaining the results of the tests requested by a previous SEND
DIAGNOSTIC (1Dh) command.
Obtaining a full or partial dump of the CTS’s memory.
Obtaining a trace of SCSI and servo command activity for the CTS.
Note: To ensure that the diagnostic results are up-to-date and
accurate, be sure that the RECEIVE DIAGNOSTIC RESULTS
command immediately follows the SEND DIAGNOSTIC
command and that the CTS is reserved for the initiator’s
exclusive use.
As described in this chapter, the bit and byte settings for the RECEIVE
DIAGNOSTIC RESULTS command descriptor block depend on
whether you are using the command to obtain diagnostic results data
or command trace data.
16-2
EXB-8205 and EXB-8505
(Standard and XL)
510503
16 RECEIVE DIAGNOSTIC RESULTS (1Ch)
Comentários a estes Manuais