Exabyte EXB-8205 Instruções de Operação Página 328

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 446
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 327
26.2 Field Definitions
Byte 01, Bits 2 through 0 - Mode
TheModefielddeterminesthetypeofoperationtobeperformed.The
only operation supported by the CTS is loading and saving the
microcode. The bits in this field must be set to 101b.
Byte 02 - Buffer ID
This field must be 0.
Bytes 03 through 05 - Buffer Offset
The value you specify for the Buffer Offset field depends on whether
you are issuing one WRITE BUFFER command or several WRITE
BUFFER commands, as follows:
If you are using one WRITE BUFFER command, set this field to 0.
If you are using more than one WRITE BUFFER command, set
this field to the total number of bytes sent by the previous WRITE
BUFFER commands in the command sequence.
Bytes 06 through 08 - Parameter List Length
The Parameter List Length field specifies the number of bytes to be
transferred by the current WRITE BUFFER command. The value you
specify for this field depends on whether you are issuing one WRITE
BUFFER command or several WRITE BUFFER commands, as follows:
If you are using only one WRITE BUFFER command, specify
exactly 54E28h (347,688 bytes) for the Parameter List Length.
If you are using more than one WRITE BUFFER command,
specify a multiple of 400h for each Parameter List Length (must
be greater than 0). Be sure to set the WBF bit to 1. Then, for the
last WRITE BUFFER command in the sequence, set the Parameter
List Length to the remaining length (that is, set it to 54E28h minus
the total of the previous Parameter List Lengths). Set the WBF bit
to 0.
Note: The Parameter List Length for the last WRITE BUFFER
command does not need to be a multiple of 400h, but it
must be greater than 0.
//different numbers for 8500//
26-4
EXB-8205 and EXB-8505
(Standard and XL)
510503
26 WRITE BUFFER (3Bh)
Vista de página 327
1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 445 446

Comentários a estes Manuais

Sem comentários